-18-
Model G0895 (Mfd. Since 01/20)
Inventory
The following is a list of items shipped with your
machine. Before beginning setup, lay these items
out and inventory them.
If any non-proprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.
Box 1 (Figure 12) Qty
C. Hand-Held Controller ................................. 1
D. Hose Clamps 2" ......................................... 2
E. 50-Pin Cable .............................................. 1
F. ER32 Collet
1
⁄
4
" ........................................... 1
G. ER32 Collet
1
⁄
2
" ........................................... 1
H. Spindle Nut ................................................. 1
I. Dust Shoe ................................................... 1
J. Cap Screw M5-.8 x 30 ............................... 1
K. Dust Shoe Bracket ..................................... 1
L. Hex Nut M5-.8 ............................................ 1
M. Gasket Tube ......................................... 68 ft.
N. Open-End Wrench 30/32mm ..................... 1
O. ER32 Collet Wrench ................................... 1
P. USB Cable .................................................. 1
Q. T-Slot Bolts M8-1.25 x 80 ........................... 6
R. Clamp Plates .............................................. 6
S. Flat Washers 8mm ..................................... 6
T. Wing Nuts M8-1.25 ..................................... 6
U. Hex Bolts M8-1.25 x 40 ............................. 6
NOTICE
If you cannot find an item on this list, care-
fully check around/inside the machine and
packaging materials. Often, these items get
lost in packaging materials while unpack-
ing or they are pre-installed at the factory.
Crate (Not Shown)
Qty
A. CNC Router ................................................ 1
B. Vacuum Hose 2" ......................................... 1
Figure 12.
G0895 inventory.
C
D
E
F
G
H
I
J
K
L
M
N
O
P
Q
R
S
T
U
Содержание G0895
Страница 60: ......
