Grizzly G0809, Руководство пользователя

Страница: 24 / 72

-22-
Model G0809 (Mfd. Since 1/17)
Dust Collection
Minimum CFM at Dust Port: 400 CFM
Do not confuse this CFM recommendation with
the rating of the dust collector. To determine the
CFM at the dust port, you must consider these
variables: (1) CFM rating of the dust collector,
(2) hose type and length between the dust col-
lector and the machine, (3) number of branches
or wyes, and (4) amount of other open lines
throughout the system. Explaining how to cal-
culate these variables is beyond the scope of
this manual. Consult an expert or purchase a
good dust collection "how-to" book.
This machine creates a lot of wood chips/
dust during operation. Breathing airborne
dust on a regular basis can result in perma-
nent respiratory illness. Reduce your risk
by wearing a respirator and capturing the
dust with a dust collection system.
To connect dust collection hose:
1. Fit 4" dust hose over dust port, as shown
in Figure 20, and secure with included wire
hose clamp.
Figure 20. Dust hose attached to dust port.
2. Tug hose to make sure it does not come off.
Note: A tight fit is necessary for proper
performance.
Dust Port
Dust
Hose
The jointer outfeed table MUST be level
with cutterhead knives when they are at top
dead center (at their highest point during
rotation). Otherwise, the workpiece may not
properly feed past the cutterhead, which
may result in kickback or related injuries.
10. Place straightedge on outfeed table so it
extends over cutterhead, and use cutterhead
pulley to rotate cutterhead until one of the
knives is at top dead center (their high-
est point during rotation), as illustrated in
Figure 19.
Straightedge
Outfeed Infeed
Figure 19. Using straightedge to check outfeed
table height.
When outfeed table height is correctly set,
knife (at top dead center) will barely touch
straightedge, as illustrated in
Figure 19.
— If knife lifts straightedge off table or is
below straightedge, then outfeed table
height must be reset (refer to
Setting
Outfeed Table Height on Page 47 for
detailed instructions).