Grizzly G0771, Руководство пользователя

Страница: 23 / 84

Model G0771 (Mfd. Since 8/15)
-21-
14. Install handwheels on shafts, making sure
notch in each wheel fits over pin on each
shaft, and secure with star knobs, as shown
in
Figure 28.
Figure 28. Handwheel Installed.
Notch Star Knob
15. Install saw blade as instructed in Blade
Installation on Page 29.
16. Raise motor slightly, using blade height
handwheel, and remove styrofoam block
that supports motor during shipping (see
Figure 29).
Figure 29. Location of styrofoam block to be
removed.
12. Install rear fence rail on backside of table
using (8) M8-1.25 x 20 cap screws. Be sure
lip of fence rail faces up and away from table,
as shown in
Figure 26.
Figure 26. Mounting rear fence rail.
Lip
Figure 25. Switch installed.
x 2
11. Install switch onto hex bolts from Step 6
using (2) M8-1.25 hex nuts (see Figure 25).
13. Install table/dado insert in table throat (see
Figure 27). Check to make sure it is flush
and adjust if necessary (see
Table/Dado
Insert Adjustment on Page 66 for more
information).
Figure 27. Table insert installed.