Grizzly G0764Z, Руководство пользователя

Страница: 71 / 118

Model G0764Z (Mfd. Since 10/15)
-69-
Lubrication
An essential part of lubrication is cleaning the
components before lubricating them. This step
is critical because dust and chips build up on
lubricated components, which makes them hard
to move. Simply adding more lubrication to built-
up grime will not result in smooth-moving parts.
Clean the components in this section with an oil/
grease solvent cleaner or mineral spirits before
applying lubrication.
All bearings are sealed and permanently lubri-
cated. Leave them alone until they need to be
replaced. Refer to
Page 66 for NLGI#2 grease
(T23964) available from Grizzly.
Slide Shafts
Lubrication Type ...T23964 or NLGI#2 Equivalent
Amount .............................................. 1–2 Pumps
Lubrication Frequency .....................6–12 Months
The blades and motors move up and down on
slide shafts that require adding lubricant to the
grease fittings shown in
Figures 142–144.
To reduce risk of shock or
accidental startup, always
disconnect machine from
power before adjustments,
maintenance, or service.
Elevation Chain
Lubrication Type .......... G4682 Dry Coating Lube
Amount .................................................Thin Coat
Lubrication Frequency .....................6–12 Months
Clean the chain links (see
Figure 143) with a
brush and mineral spirits, then apply a light coat
of lubricant.
Tilt Leadscrew
Lubrication Type ...T23964 or NLGI#2 Equivalent
Amount .................................................Thin Coat
Lubrication Frequency .....................6–12 Months
Clean the threads of the tilt leadscrew (see
Figure 144) with a stiff brush and mineral spirits.
When dry, apply a thin coat of lubricant into the
threads with a brush and tilt the blade back and
forth a few times to distribute the grease.
Figure 143. Location of elevation chain.
Elevation
Chain
Figure 144. Tilt leadscrew.
Tilt
Leadscrew
Figure 142. Sliding shafts and grease fittings.
Sliding
Shafts
Grease
Fittings