Grizzly G0757, Руководство пользователя

Страница: 50 / 84

-44-
Model G0757 (Mfg. Since 6/13)
Table Leadscrews
Oil Type ......Model T23962 or ISO 68 Equivalent
Oil Amount ............................................Thin Coat
Lubrication Frequency .........40 Hrs. of Operation
Move the table as necessary to access the entire
length of the X-, Y-, and Z-axis leadscrews (see
Figures 59–60), then use mineral spirits, shop
rags, and a brush to clean them.
Ram Ways
Oil Type ......Model T23962 or ISO 68 Equivalent
Oil Amount ............................................Thin Coat
Lubrication Frequency .........40 Hrs. of Operation
Move the ram as necessary to gain access to the
entire length of the dovetail ways (see
Figure 61),
use mineral spirits and shop rags to clean the
ways, then apply a thin coat of lubricant.
When dry, use a clean brush to apply a thin coat
of oil to the leadscrew threads, then move the
table through the X-, Y-, and Z-axis paths to dis-
tribute the oil.
Figure 59. X-axis leadscrew
(as viewed underneath the table).
X-Axis
Leadscrew
Figure 61. Ram dovetail ways.
Ram Dovetail
Ways
Z-Axis Bevel Gears
Grease Type ......... NLGI#2 Grease or Equivalent
Oil Amount ............................................Thin Coat
Lubrication Frequency .........80 Hrs. of Operation
Use mineral spirits, shop rags, and a brush to
clean the old grease from the teeth of the bevel
gears shown in
Figure 62.
When dry, use a brush to apply a thin coat of
grease to the teeth, then move the table up and
down to evenly distribute the grease.
Figure 62. Location of Z-axis bevel gears.
Figure 60. Y- and Z-axis leadscrews
(as viewed underneath the knee).
Y-Axis
Leadscrew
Z-Axis
Leadscrew