Grizzly G0757, Руководство пользователя

Страница: 49 / 84

Model G0757 (Mfg. Since 6/13)
-43-
Vertical Spindle Bearings
Oil Type ......Model T23963 or ISO 32 Equivalent
Oil Amount ......................................... 1–2 Pumps
Lubrication Frequency ...... 4–8 Hrs. of Operation
To lubricate the vertical spindle bearings:
1. Remove the circular cover on the right side of
the head to expose the vertical spindle spline
(see
Figure 57).
Quill Exterior
Oil Type ......Model T23962 or ISO 68 Equivalent
Oil Amount ............................................Thin Coat
Lubrication Frequency ...... 4–8 Hrs. of Operation
Fully extend the spindle to expose the quill (see
Figure 58), then use an oily shop rag to apply a
thin coat of lubricant to the smooth surface of the
quill.
Note: If you remove any of the grease from the
teeth of the quill rack, replace it as instructed
below.
2. Raise the spindle until you can see the top of
the quill.
3. Add 2–3 pumps from an oil can between the
spindle spline and the top of the quill.
4. Replace the circular cover and run the verti-
cal spindle for a few minutes to distribute the
oil in the bearings.
Quill Rack & Pinion
Grease Type ......... NLGI#2 Grease or Equivalent
Oil Amount ............................................Thin Coat
Lubrication Frequency .........40 Hrs. of Operation
Fully extend the spindle to expose the quill rack
(see
Figure 58), then use mineral spirits, shop
rags, and a brush to clean the old grease from the
teeth of the rack and pinion.
When dry, use a brush to apply a thin coat of
grease to the teeth, then move the quill up and
down several times to evenly distribute the grease.
Figure 57. Vertical spindle spline exposed for
lubrication.
Spindle
Spline
Exposed
Figure 58. Quill lubrication points.
Pinion
Rack
Quill
Smooth
Surface