Grizzly G0755, Руководство пользователя, Страница: 23 / 60

Model G0755 (Mfg. Since 1/13)
-21-
Headstock
Movement
the headstock travels up and down the column,
and tilts 90° left and right relative to the table.
Raising/Lowering Headstock
Loosen the lock handles shown in Figure 13, then
use the elevation (z-Axis) switch (see
Figure 14)
on the control panel to raise/lower the headstock.
Depth Stop
the depth stop limits the downward movement of
the cutting tool. With the use of the depth pointer
adjustment knob (see
D in Figure 12), it can be
adjusted anywhere within 0"–5". this is useful
when performing repeat operations.
the limit stops shown in Figure 15 stop head-
stock travel when contacted by the limit block.
the headstock can also be raised/lowered by
hand using the crank shown in
Figure 16.
Note: Lock the headstock in place by re-tighten-
ing the lock handles before beginning operation to
avoid unexpected headstock movement.
The z-axis crank will rotate rapidly and may
cause impact injuries if left attached during
powered z-axis operation. Always remove
z-axis crank before using the switch on the
control panel.
Figure 13. Lock handles for headstock elevation.
Lock
handles
Figure 15. z-axis limit controls.
Limit
stops
Limit
Block
Figure 14. elevation switch that controls
motorized head travel.
elevation
switch
Figure 16. z-axis crank.
Crank