Grizzly G0725, Руководство пользователя

Страница: 27 / 44

Model G0725 (Mfd. Since 02/20)
-25-
Setting Depth of Cut
The depth of cut on a jointer affects the amount
of material removed from the bottom of the
workpiece as it passes over the cutterhead.
The depth of cut is set by adjusting the height of
the infeed table relative to the cutterhead knives
at top dead center (TDC) and the outfeed table.
Adjusting Zero Stop
The zero stop (see
Figure 34) allows the operator
to consistently bring the infeed table even with the
outfeed table height.
Adjusting Infeed Table Height
To adjust infeed table height, rotate the infeed
table adjustment knob to raise or lower the table
(see
Figure 33).
Tools Needed Qty
Precision Straightedge 24" ................................ 1
Hex Wrench 3mm .............................................. 1
Open-End Wrench 10mm .................................. 1
Figure 34. Zero stop components.
Jam Nut
Zero Stop
Set Screw
Infeed Table
Adjustment Knob
To set zero stop:
1. Place a straightedge on top of outfeed table
(see Figure 35) and use infeed table adjust-
ment knob to raise or lower table until table
contact is even along straightedge.
Figure 35. Checking table parallelism.
Straightedge
Outfeed Table
Infeed Table
2. Loosen jam nut, and adjust zero stop set
screw until it contacts table base (see
Figure
34).
3. Tighten jam nut to secure height setting.
Figure 33. Location of infeed table adjustment
knob.
Infeed Table
Adjustment
Knob
Like all machinery there is potential danger
when operating this machine. Accidents
are frequently caused by lack of familiarity
or failure to pay attention. Use this machine
with respect and caution to decrease the
risk of operator injury. If normal safety pre-
cautions are overlooked or ignored, seri-
ous personal injury may occur.