Grizzly G0725, Руководство пользователя

Страница: 15 / 44

Model G0725 (Mfd. Since 02/20)
-13-
Inventory
The following is a list of items shipped with your
machine. Before beginning setup, lay these items
out and inventory them.
If any non-proprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.
NOTICE
If you cannot find an item on this list, care-
fully check around/inside the machine and
packaging materials. Often, these items get
lost in packaging materials while unpack-
ing or they are pre-installed at the factory.
Jointer Inventory (Figures 6–7) Qty
A. Jointer Bed Assembly................................. 1
B. Fence.......................................................... 1
C. Dust Collection Bag .................................... 1
D. Limit Block .................................................. 1
E. Push Blocks ................................................ 2
F. Fence Tilting Handle .................................. 1
G. Fence Bracket Assembly ............................ 1
H. T-Handle Torx Driver T-30 .......................... 1
I. Fence Sliding Handle ................................. 1
J. Fence Support ............................................ 1
K .
Locking Plate Assembly ............................. 1
L . Dust Chute ................................................. 1
M. Dust Collection Bag Clamp ........................ 1
N. T-Handle Hex Wrench 4mm ....................... 1
O. Hex Wrench 6mm ....................................... 1
P. Hex Wrench 5mm ....................................... 1
Hardware (Not shown)
—Cap Screws M8-1.25 x 20 ............................. 2
—Lock Washers 8mm ....................................... 2
—Cap Screws M6-1 x 20 .................................. 2
—Lock Washers 6mm ....................................... 2
Figure 6. Large components.
A
B
Figure 7. Small components.
C
D
F
E
G
K
H
J
I
L
N
M
O
P