Grizzly G0725, Руководство пользователя

Страница: 25 / 44

Model G0725 (Mfd. Since 02/20)
-23-
Setting Fence Stops
The fence angle stops simplify the task of adjust-
ing the fence to 45° inward, 90°, and 45° outward
(135°).
Items Needed Qty
45° Square ........................................................ 1
90° Square ........................................................ 1
Sliding Bevel ...................................................... 1
Open-End Wrench 10mm .................................. 1
Hex Wrench 6mm .............................................. 1
Flathead Screwdriver ......................................... 1
3. Use a 90° square to adjust fence to 90° (see
Figure 27), then tighten fence tilting handle.
Note: Fence should stop at 90º when it con-
tacts limit block shaft (see
Figure 28).
Setting 90° Fence Stop
1. DISCONNECT MACHINE FROM POWER!
2. Loosen fence tilting handle (see Figure 26),
and press limit plate tab forward into limit
block rear slot.
— If fence stops at 90° when it contacts limit
block shaft, it is adjusted correctly. No fur-
ther adjustments are necessary.
— If fence does not stop at 90° when it
contacts limit block shaft, 90° stop is not
adjusted correctly. Proceed to
Steps 4–6.
4. Bring fence to 90°, then loosen jam nut locat-
ed on rear of limit block shaft (see Figure 28)
Note: Keep limit plate in limit block rear slot
while making adjustments.
5. Turn limit block shaft until it contacts fence.
6. Re-tighten jam nut. The 90° stop is now set
precisely.
Figure 26. Fence carriage overview.
Fence Tilting
Handle
Fence Sliding
Handle
Figure 27. Checking the 90º stop.
90°
Square
Figure 28. Fence stop parts identification.
Limit Block
Shaft
Limit Plate
Tab
Inward Stop
Jam Nut
Limit Block
Rear Slot
Setting 45° Fence Stop
1. DISCONNECT MACHINE FROM POWER!
2. Loosen fence tilting handle, and release
fence from 90° limit block stop.
3. Tip fence towards table as far as it will go,
ensuring limit plate stays in limit block rear
slot, then tighten fence tilting handle.
Note: When fence tilts towards table, it
will stop when it contacts inward stop (see
Figure 28).