Grizzly G0720R, Руководство пользователя

Страница: 27 / 56

Model G0720R (Mfg. Since 11/10)
-25-
5. Pull and hold the spring-loaded index pin
(see Figure 22) outward approximately
1
⁄
4
" to
disengage it while you rotate the headstock
to the desired angle as shown by the digital
protractor.
Note: The spring-loaded index pin serves
only as a quick way to return or position the
headstock close to zero, or 45° to the left or
right. It is not intended to be an exact angle
stop.
6. Snug the three hex nuts in place.
7. Place the appropriate angle finding tooling
on the workpiece or milling table, and fine-
tune your angle adjustment and alignments
according to standard machine shop prac-
tices.
8. When satisfied with the position of the head-
stock, tighten the three hex nuts, and recheck
your settings.
Note: As described earlier in the manual, the
digital protractor is equipped with an auto-
shutoff feature. So if during setup or milling
operations it shuts
OFF, your angle setting
is retained in volatile memory. When the pro-
tractor is needed again, push the ON/OFF
button and the digital display will retrieve and
show the last angle or grade measured.
Tilting
1. DISCONNECT MILL FROM POWER!
2. On the digital protractor shown in Figure 21,
press the ON/OFF button to turn it ON, and
press
CALIBRATE to set its digital display to
zero.
Figure 21. Digital protractor.
Figure 22. Headstock tilt locking hex nuts.
Index Pin
Left Hex Nut
Right Hex Nut
Lower Hex Nut
3. Press 0% button to select the type of angle
units shown on the digital display.
4. Located on the headstock swivel mount,
loosen the left, right, and lower headstock tilt
lock nuts shown in
Figure 22.