Grizzly G0718, Руководство пользователя

Страница: 27 / 52

Model G0718 (Mfd. Since 12/10)
-25-
Figure 32. Removing inner cap screws.
4. Remove the (2) M6-1 x 45 and (2) M6-1 x 55
cap screws from both sides of the swing arm
assembly, then slide the swing arm off the
head.
Figure 31. Removing swing arm assembly
5. Remove the (4) M6-1 x 65 cap screws at
the inside holes shown in Figure 32, then
remove the boring head from the spindle.
6. Install the new boring head in the reverse
order or removal.
Installing & Adjusting Boring Bits
Boring bits have a flat surface on the shank (see
Figure 33) to facilitate easy and secure mounting,
and they have an adjusting screw for offsetting the
drilling depth in relation to the other bits.
Figure 33. Boring bit.
Flat on Shank
Adjusting
Screw
To install boring bits:
1. DISCONNECT BORING MACHINE FROM
POWER!
2. Remove the clear guard.
3. Position the adjusting screws on all of the bits
(see Figure 33) even with the top of the bit
housing.
This sets the bottom of the bits flush so all the
holes are drilled at the same depth, as shown
in
Figure 34. The tips of the mounting screws
thread into the workpiece slightly below the
cup. This setting works well for most hinges.
Bits Set Even
Drilled Workpiece
Hinge Installed
Figure 34. Hinge bits set even, holes drilled in
workpiece, hinge installed.
M6-1 x 55
Cap Screw
M6-1 x 45
Cap Screw
M6-1 x 65 Cap Screws
(3 of 4 Shown)