Grizzly G0718, Руководство пользователя

Страница: 18 / 52

-16-
Model G0718 (Mfd. Since 12/10)
Assembly
3. Remove the fasteners from the pivot connec-
tor (see Figure 11), raise the handle pivot
bar, and use the fasteners to secure the han-
dle pivot bar to the vertical pivot bar through
the mounting holes shown.
4. Loosen the cap screws on the fence exten-
sion rods, slide the rods out about half their
length (see
Figure 12), then tighten two of the
screws to secure the rods to the extension.
The handle was secured to the machine in a spe-
cial way to protect it from shipping damage. As
such, the way it is mounted for shipping is not how
it should be mounted for operation. The assembly
process involves re-mounting the handle in its
operating position and installing all loose compo-
nents from the shipping box.
The machine requires, but does not include,
a boring head in order to perform operations.
Grizzly offers a number of boring heads for this
machine (refer to
Page 32 for more details). The
boring head must be installed before performing
the
Test Run procedure. To choose the correct
boring head, refer to Selecting Boring Head on
Page 24.
Serious personal injury could occur if you
connect the machine to power before com-
pleting the setup process. DO NOT connect
power until instructed later in this manual.
To assemble your boring machine:
1. DISCONNECT BORING MACHINE FROM
POWER!
2. Remove and discard the cable ties that
secure the downfeed handle (see Figure 11).
Figure 11. Cable ties and pivot connector.
Vertical Pivot Bar
Pivot Connector
Mounting
Hole
Cable Tie
(1 of 2)
Handle Pivot Bar
Note: The fence extension is only needed for
certain applications, such as 3-hinge doors.
Therefore, installation is optional depending
on anticipated needs.
The fence extension can be mounted on the
left or right end of the table fence for different
applications. If mounting the fence extension
on the right side, you must swap the left scale
on the fence extension with the provided right
scale. This ensures the numbering sequence
between the table fence scale and the fence
extension scale are congruent.
Figure 12. Fence extension rods and cap
screws (shown from right rear of table).
Cap
Screw
Fence
Extension
Rods
Cap
Screw
Table
Fence
Fence
Extension