Grizzly G0633, Руководство пользователя

Страница: 48 / 72

-46-
G0633/G0634 Jointer/Planer Combo Machine
The depth scale on the infeed table can be cali-
brated or "zeroed" if it is not correct.
Tools Needed Qty
Straightedge ...................................................... 1
Phillips Screwdriver ........................................... 1
To calibrate the depth scale:
1. DISCONNECT THE JOINTER/PLANER
FROM THE POWER SOURCE!
2.
Set the outfeed table height as described in
the Setting Outfeed Table Height instruc-
tions on
Page 18
.
3.
Use the straightedge to help adjust the infeed
table exactly even with the outfeed table, as
shown in
Figure 65
.
Calibrating Depth
Scale
Pulley Alignment
Figure 67 . Fence and V-belt cover removed.
2.
Place a 2" C-clamp on each pulley so the
adjustment shaft faces out, place a straight-
edge on the clamps, as shown in
Figure 68
,
and visually check pulley alignment.
Figure 68.
Checking belt alignment.
4.
Using a screwdriver, adjust the scale pointer
to zero (
Figure 66
).
Figure 65. Infeed table even with outfeed table.
������������
������ �������
Figure 66. Depth scale adjusted to “0” position.
Tools Needed: Qty
Straightedge ...................................................... 1
Hex Wrench 3mm .............................................. 1
C-Clamps ........................................................... 2
Proper pulley alignment (see Figure 68 ) prevents
premature belt wear. The pulleys are properly
aligned when they are parallel and in the same
plane as each other.
To align the pulleys:
1.
Remove the fence assembly, fence bracket,
and the V-belt cover ( Figure 67 ).