Grizzly G0611X, Руководство пользователя

Страница: 38 / 52

-36-
Model G0611X (Mfd. 07/15)
Figure 59. Dust plug removed to see bottom of
cutter spindle for belt removal.
4. Loosen the two motor mount cap screws
shown in
Figure 57.
5. Turn the motor tension bolt, shown in
Figure 58, counterclockwise to loosen the
belt.
6. Slide the belt under the top of the spindle
shaft and off the motor pulley.
7. Reinstall and tension the new belt.
8. Replace the dust plug, and tighten the motor
mount cap screws.
Replacing Belt
If the belt is left loose, it can stop during operation
while the pulley continues to spin. This scenario
will burn the belt, which will create a horrible vibra-
tion and smell of burned rubber. If this happens,
then the belt must be replaced before continuing
operations.
Tools Needed Qty
Hex Wrench 6mm .............................................. 1
To replace the belt:
1. DISCONNECT MACHINE FROM POWER!
2. Lower the cutter as far as it will go.
3. Remove the dust plug shown in Figure 59 to
access the bottom of the belt.
3. Turn the belt tension bolt, shown in Figure 58,
clockwise to tension the belt.
Note: Each time you adjust the belt tension,
only turn the bolt one full turn. This will pre-
vent over-tightening the belt, which can lead
to premature bearing failure in the motor and
spindle.
4. Tighten the motor mount cap screws.
Figure 58. Belt tension bolt.
Belt Tension Bolt
Access
Hole