Grizzly G0611X, Руководство пользователя

Страница: 24 / 52

-22-
Model G0611X (Mfd. 07/15)
To change the template bar size:
1. Remove the extension spring shown in
Figure 22, and pull the headstock backward
(toward you) to clear the tracer pin of the tem-
plate.
Setting Fences
The dovetail machine features HDPE (high den-
sity polyethylene) plastic fences for both the
horizontal and vertical workpieces (see
Figure
24). These fences are cut into during operation to
reduce tear-out.
Figure 24. HDPE fences.
The fences should be set so that the dovetails
are evenly distributed across the width of the
workpiece. Setting the fences requires attention to
the "in" and "out" positions of the tracer pin (see
Figure 25). When the tracer pin is in the "in" posi-
tion, the cutter is cutting the workpiece. When the
tracer is in the "out" position, the cutter is outside
of the workpiece.
To set the fences:
1. DISCONNECT MACHINE FROM POWER!
2. Remove the guard.
3. Place the vertical workpiece on the support
bar.
Out
Position
In
Position
Tracer Pin
Template
Bar
Figure 25. Tracer pin positions (as viewed from
underneath template bar).
Figure 22. Extension spring (located on the right
side of the headstock).
Extension Spring
2. Remove the wing screw on each side of the
template bar.
3. Slide the template bar out of the casting and
reinstall it, as shown in
Figure 23, so the
desired template size is facing down.
4. Lock the template in place with the wing
screws, then replace the extension spring.
Template Bar
Wing
Screw
Wing
Screw
Figure 23. Template bar installation.
Vertical Fence
Horizontal Fence