Model G0611X (Mfd. 07/15)
-17-
Test Run
To test run the machine:
1. Clear all setup tools away from machine.
2. Press Emergency Stop button in.
3. Connect machine to power by inserting power
cord plug into a matching receptacle.
4. Twist Emergency Stop button clockwise until
it springs out. This resets the switch so the
machine can start.
Once assembly is complete, test run the machine
to ensure it is properly connected to power and
safety components are functioning correctly.
If you find an unusual problem during the test run,
immediately stop the machine, disconnect it from
power, and fix the problem BEFORE operating the
machine again. The
Troubleshooting table in the
SERVICE section of this manual can help.
DO NOT start machine until all preceding
setup instructions have been performed.
Operating an improperly set up machine
may result in malfunction or unexpect-
ed results that can lead to serious injury,
death, or machine/property damage.
Serious injury or death can result from
using this machine BEFORE understanding
its controls and related safety information.
DO NOT operate, or allow others to operate,
machine until the information is understood.
5. Verify that the machine is operating correctly
by turning it
ON.
—When operating correctly, the machine
runs smoothly with little or no vibration or
rubbing noises.
— Investigate and correct strange or unusual
noises or vibrations before operating the
machine further. Always disconnect the
machine from power when investigating or
correcting potential problems.
6. Turn the machine OFF.
7. Push the STOP button in to make sure it is
NOT popped out.
8. Press the green ON button.
—If the machine starts, immediately stop the
machine. The switch disabling feature is
not working correctly. This safety feature
must work properly before proceeding with
regular operations. Call Tech Support for
help.
—If the machine does not start, the switch
disabling feature is working as designed.
9. Verify that the cutter is turning the correct
direction by starting the motor, then stopping
the motor while watching the cutter through
the guard window.
— If the cutter turns counterclockwise, it is
turning in the correct direction. Proceed to
Step 10.
— If the cutter turns clockwise, it is turning in
the wrong direction. Contact our Technical
Support department for help.
10. Test the clamps. The clamps should clamp
down when the switch is turned ON and they
should raise up when the switch is turned
OFF.
—If the clamps work as stated, no additional
adjustments are necessary.
— If the clamps do not work as stated, trou-
bleshoot and correct the clamping system.
Contact our Technical Support department
for help.
The test run consists of verifying the following: 1)
The motor powers up and runs correctly, 2) the
stop button safety feature works correctly, and 3)
the motor turns the correct direction (machine is
not wired out of phase).
Содержание G0611X
Страница 52: ......
