Grizzly G0577, Инструкция по эксплуатации

Страница: 10 / 20

-8-
G0577 Fretboard Radiusing Attachment
Assembly
To install the fretboard radiusing attachment
onto the sander:
1.
Slide the slot in the short support bracket
onto the rotation plate and loosely attach the
bracket to the platen with two
3
⁄
8
"-16 x 2" hex
bolts, four flat washers, and two hex nuts.
Note— Some machines may require the
included
3
⁄
8
" thick shim between the bracket
and the platen.
2. Align the hole in the short support bracket
with the hole in the rotation plate and loosely
secure it with a
3
⁄
8
"-16 x 1½" hex bolt with a
flat washer.
3.
Plumb the short support bracket as shown in
Figure 6 and tighten the bolts.
4.
Install the long support bracket with three
3
⁄
8
"-
16 x 1" hex bolts and washers.
5. Plumb the long support bracket and tighten
the bolts.
6.
Remove the upper right motor mounting
bolt.
Figure 6.
Plumbing the short support bracket.
7. Install the cross brace as shown in Figure
7
with three
5
⁄
16
"-18 x 2½" hex bolts, six flat
washers, and three hex nuts.
Cross Brace
Figure 7.
Cross brace placement.
8. Slide the horizontal adjustment tubes through
the guide rails as shown in
Figure 8
, with the
threaded holes towards the outside of the
machine, and tighten the hex bolts.
Figure 8.
Guide rail installation.
Guide Rail B
Guide Rail A
Horizontal
Adjustment
Tube