Grizzly G0555LX, Руководство пользователя

Страница: 21 / 68

Model G0555LX (Mfd. Since 1/14)
-19-
7. With the help of other people, lift the bandsaw
assembly onto the stand and align the mount-
ing holes. Have one person hold the bandsaw
in place to keep it from falling until you can
complete the next step.
8. Secure the bandsaw assembly to the stand
with (4)
5
⁄
16
"-18 x 1
1
⁄
2
" hex bolts, (4)
5
⁄
16
" lock
washers, (8)
5
⁄
16
" flat washers, and (4)
5
⁄
16
"-18
hex nuts, as shown in Figure 14.
Figure 14. Bandsaw assembly attached to the
stand.
x 4
Figure 15. Trunnion installed (table removed for
clarity).
x 2
Trunnion
9. Remove the table insert and table pin, line up
the table slot with the blade, then position the
table so that the blade is in the center cut-out.
10. Rotate the table so that the table slot faces
to the right, then position the table trunnion
on the bandsaw, as shown in
Figure 15, and
secure it with (2)
5
⁄
16
"-18 x 1
1
⁄
4
" hex bolts and
(2)
5
⁄
16
" lock washers.
11. Tighten the trunnion lock knobs to secure the
table.
12. Re-install the table insert and table pin, as
shown in
Figure 16.
IMPORTANT: Make sure you re-install the
table pin. This pin keeps the table surfaces
on either side of the slot even with the chang-
es in operating pressures and temperature
changes.
Figure 17. Installing rear fence rail.
Rear Fence
Rail
x 2
Figure 16. Table pin and insert installed.
13. Attach the rear fence rail to the rear of the
table with (2)
1
⁄
4
"-20 x
5
⁄
8
" cap screws, as
shown in
Figure 17.