Grizzly G0526A40, Руководство пользователя

Страница: 48 / 60

-46-
Model G0526A40 (Mfd. Since 12/22)
The cutterhead guard is designed to reduce the
risk of accidental contact with hands or fingers
with the spinning cutterhead. When properly
installed and functioning correctly, the guard auto-
matically rotates clear of the cutterhead during the
cutting operation and then springs back over the
cutterhead as soon as the operation is complete.
In order to function as intended, the guard must
be installed as low as possible over the infeed
table without actually touching it (approximately
1
⁄
16
" above infeed table), and it must have enough
spring tension at the mounting shaft to quickly
reposition itself against the fence after it is rotated
away from the cutterhead and released. Before
performing rabbeting operations, adjust guard
height to just clear outfeed table.
Item(s) Needed Qty
Additional Person .............................................. 1
Precision Ruler 6" .............................................. 1
Phillips Head Screwdriver #2 ............................ 1
Hex Wrench 3mm .............................................. 1
Checking/Adjusting
Cutterhead Guard
The cutterhead guard is a critical safety
feature of this jointer. You MUST verify its
operation before using the jointer! Failure
to properly install this guard will greatly
increase risk of serious personal injury.
To check/adjust cutterhead guard:
1. DISCONNECT MACHINE FROM POWER!
2. Pull cutterhead guard away from fence and
let it go (see Figure 64).
— If cutterhead guard does spring back over
cutterhead, contacts fence, and does not
drag across infeed table, then cutterhead
guard is properly adjusted.
— If cutterhead guard does not spring back
over cutterhead, does not contact fence,
or drags across infeed table, proceed to
Step 3.
Figure 64. Cutterhead guard components.
Cutterhead Guard