Grizzly G0526A40, Руководство пользователя

Страница: 43 / 60

Model G0526A40 (Mfd. Since 12/22)
-41-
3. Loosen infeed table lock handle (see
Figure 51).
4. Adjust infeed table until it is level with outfeed
table (see
Figure 50).
5. Loosen Phillips head screw on depth scale
pointer, adjust pointer to "0", then tighten
screw to secure position (see
Figure 51).
6. Tighten infeed table lock handle to secure
position.
The function of the table gibs is to eliminate
excessive play in the table movement. The gibs
also control how easy it will be to move the tables
up and down.
Tools Needed Qty
Open-End Wrench 12mm .................................. 1
Hex Wrench 4mm .............................................. 1
To adjust table gibs:
1. DISCONNECT MACHINE FROM POWER!
2. Loosen two infeed table gib nuts on front of
jointer base (see Figure 52).
Adjusting Gibs
3. Oil table ways and outfeed leadscrew if
needed (see
Page 34).
4. Evenly tighten gib set screws a small amount,
then check table by moving it up and down.
Adjust set screws as needed until friction of
table movement is balanced between mini-
mal play and ease of movement, then tighten
gib nuts to secure.
Note: Tighter gibs reduce play but make it
harder to adjust tables.
5. Repeat Steps 2
–4 with outfeed table.
6. Set outfeed table height as described in
Setting Outfeed Table Height on Page 39.
Figure 52. Infeed table gib controls.
Gib Nut
(1 of 4)
Gib Set Screw
(1 of 4)
Figure 51. Infeed table depth scale components.
Infeed Table Lock Handle