Grizzly G0526A40, Руководство пользователя

Страница: 42 / 60

-40-
Model G0526A40 (Mfd. Since 12/22)
Calibrating Depth
Scale
The depth scale can be calibrated or "zeroed" to
make sure the cutting depth shown on the scale
matches the actual cutting depth (per pass).
To calibrate the depth scale:
1. Set the outfeed table height as described in
Setting Outfeed Table Height.
2. Place a straightedge across the infeed and
outfeed tables.
3. Adjust the infeed table until it is level with the
outfeed table, as shown below.
4. Using a screwdriver, precisely adjust the
scale pointer to “0”.
Tools Needed Qty
Straightedge 12" ................................................ 1
Phillips Head Screwdriver #2 ............................ 1
Open-End Wrenches 12mm .............................. 2
To calibrate depth scale:
1. DISCONNECT MACHINE FROM POWER!
2. Place straightedge across infeed and outfeed
tables (see Figure 50).
Before beginning, set outfeed table height as
described in
Setting Outfeed Table Height.
5. Use motor pulley to rotate cutterhead until
one insert is at TDC (its highest point during
rotation), as shown in
Figures 48–49.
Straightedge
Outfeed Infeed
Figure 49. Using straightedge to check outfeed
table height.
Figure 48. Cutterhead insert at TDC.
Bottom Dead
Center
Top Dead
Center
Figure 50. Infeed table adjusted even with
outfeed table.
Straightedge
Infeed Outfeed
6. Use outfeed table handwheel to set outfeed
table so insert barely touches straightedge,
as shown in
Figure 49.
7. Tighten outfeed table lock so outfeed table
will not move during operation.
8. Re-install cutterhead guard, fence, and
cabinet rear access panel.