Grizzly G0524, Руководство пользователя, Страница: 29 / 60

Model G0524 (Mfd. Since 7/16)
-27-
Figure 31. Rip cutting operation. The operator
is standing to the side of the workpiece to avoid
injury in the event of kickback.
12. Push the workpiece into the saw to perform
the cutting operation (
Figure 31).
— If the saw is not cutting completely through
to the bottom face of the workpiece, the
blade needs to be lowered. Only lower
the blade just enough to cut complete-
ly through the workpiece. Lowering the
blade too far could cause the blade to
make contact with the conveyor track.
Never stand directly behind the workpiece
while feeding it through the rip saw. Stand
to the left or right of the workpiece to avoid
serious personal injury in the event of kick-
back.
10. Approximately 5 seconds after the arbor is
started, press the FEED MOTOR START
button. The conveyor track should start and
run smoothly. Note—An automatic time delay
prevents the conveyor track from starting
up until 5 seconds after the main motor has
started.
11. Place the jointed edge of the workpiece
against the fence and keep fingers and hands
on top side of the workpiece. Note—Placing
hands or fingers underneath the workpiece
could cause them to become pinched onto
the conveyor track and pulled into the saw
blade.
Placing hands or
fingers under the
workpiece could cause
them to be pulled into
the rip saw, causing
serious personal inju-
ry. Do not place hands
or fingers under the
workpiece.
Never attempt to rip a board that does not
have one perfectly straight edge. Always
guide the straight edge of the board against
the rip fence. Failure to do this could result
in kickback and serious personal injury.