Grizzly G0479, Руководство пользователя

Страница: 24 / 36

18 G0578 40" Pan and Box Brake
Figure 16.
Clamping pressure adjusting nut
(one side).
The correct clamping pressure depends on the
workpiece thickness. The ideal pressure will
have medium/hard resistance and will lock the
workpiece into position easily—much like a pair
of vice grips. This pressure is adjusted by moving
the clamping pressure adjusting nuts, shown in
Figure 16
, located on both sides of the pan and
box brake.
Adjusting Clamping
Pressure
To adjust the clamping pressure:
1.
Lower the bending leaf.
2.
Place the workpiece between the fingers and
the clamping block.
3. Push the foot pedal down and lock it in
place.
— If the foot pedal will not lock in place,
loosen the clamping pressure evenly until
it will lock.
— If the foot pedal locks in place but the
workpiece is not clamped snug, tighten
the clamping pressure.
Aligning Fingers
Finger alignment is critical for accurate results.
Tools Needed: QTY
8MM Hex Wrench .............................................. 1
To align a finger:
1.
Disengage the foot pedal.
2.
Lower the bending leaf.
3.
Loosen the cap screw(s) on a finger enough
to move it up or down without resistance.
4. Push the finger firmly up against the lower
edge of the clamping leaf and tighten the cap
screw(s), as shown in
Figure 17 .
Figure 17.
Tightening capscrew on finger.
Lower Edge of
Clamping Leaf
Continued on next page