Grizzly G0452, Руководство пользователя

Страница: 51 / 64

Model G0452/P/Z (Mfg. Since 08/12)
-49-
To set the 45˚ outward fence stop:
1. Flip the 90˚ swing stop out of the way as
shown in Figure 76.
2. Using a sliding bevel adjusted to 135˚, adjust
the fence to the 135˚ (45˚ outward) position.
4. Adjust the 45˚ outward fence stop bolt until it
makes contact with the back of the fence.
5. Retighten the jam nut loosened in Step 3 and
recheck.
Figure 77. 45˚ outward fence stop jam nut.
Fence Stop Bolt
The function of the table gibs is to eliminate
excessive play in the table movement. The gibs
also control how easy it will be to move the tables
up and down.
To adjust the table gibs:
1. Using a 10mm wrench, loosen the two outfeed
table gib nuts on the side of the jointer base
(
Figure 78).
Figure 78. Outfeed table gib controls.
2. Using a 3mm hex wrench, evenly tighten the
gib setscrews a small amount, then check the
table by moving it up and down. Adjust the
setscrews as needed until the friction of the
table movement is balanced between mini-
mal play and ease of movement.
Note: Tighter gibs reduce play but make it
harder to adjust the tables.
3. Repeat Steps 1-2 with the other table.
4. Set the outfeed table height as described in
Setting Outfeed Table Height on Page 26.
3. Loosen the jam nut on the 45˚ outward fence
stop bolt (
Figure 77).
Figure 76. Adjusting fence 45˚ outward.
Swing Stop
Gib Nuts
Gib Setscrews
Adjusting Gibs