Grizzly G0452, Руководство пользователя

Страница: 22 / 64

-20-
Model G0452/P/Z (Mfg. Since 08/12)
6. Tighten the set screws, replace the V-belts,
and repeat Step 4. Belts should be parallel
and aligned as shown in Figure 16.
3. Carefully allow the motor to slide down, ten-
sioning the V-belts with the weight of the
motor.
4. Looking from the top, sight down the V-belt
and pulleys and check to see that the pulleys
are parallel and aligned with each other (see
Figure 16).
— If the pulleys are aligned, tighten the
motor mounts loosened in Step 1 and go
to
Step 7.
— If the pulleys are NOT aligned, perform
Steps 5 & 6.
5. Remove the V-belt, loosen the set screws
on the end of the motor pulley, and align
the motor pulley with the cutterhead pulley.
If needed, the motor can be loosened and
moved in or out to bring the motor pulley into
alignment with the cutterhead pulley.
7. Replace the access cover on the cabinet.
2. Lift the motor up far enough to allow the
V-belts to be placed around the cutterhead
pulley and the motor pulley (see
Figure 15).
Figure 15. Installing V-belt.
Alignment
Setscrew
Motor Pulley
Motor
Cutterhead
Pulley
Cutterhead
Figure 16. The pulleys should be parallel and
aligned.
Components and Hardware Needed: Qty
V-Belt ................................................................. 1
Tools Needed: Qty
Wrench or Socket 13mm .................................. 1
Hex Wrench 6mm .............................................. 1
To install the V-belt:
1. Using a 13mm wrench, loosen, but DO NOT
remove the motor mount bolts.
V-Belt