20
English
5.1 Setting operating mode
By the control panel it is possible to select one of the following operating modes:
• using DMX512 signal control mode
Each fixture is controlled from DMX512 signal control.
(see chapter
6.0 DMX function
)
• MASTER-SLAVE or AUTOMATIC mode (ONLY RGBW and DW)
The projector operates independently, without DMX512 signal control.
(see chapter
7.0 MASTER/SLAVE and AUTOMATIC function
)
• using FIXED COLOURS mode (ONLY RGBW and DW)
The projector operates independently, without DMX512 signal control.
(see chapter
8.0 FIXED COLOURS function
)
The unit NORMALLY works in DMX mode and, on turning on, the display will read the number of DMX address (e.g. 012).
If on turning on the display will read “AUT”, it will mean that the unit is working in AUTOMATIC mode.
Disable this function to go back to the DMX mode.
If on turning on, the display will read “COL”, it will mean that the unit is working in FIXED COLOURS mode.
Disable this function to go back to the DMX mode.
5.2 Unit control panel
The display of the unit is programmed to turn off
automatically after 20 seconds of non working.
To activate it just press “UP” “DOWN” “UP” “DOWN” keys.
When the display is actice, the luminous intensity is dim-
mered to 10% in order to avoid blind effect.
In the presence of DMX signal, the DMX led (right decimal
point) will be steady on, in the absence of signal, the red
led will be off, while in Master mode the red led will flash.
5.2.1 Reading the display and using controls
MENU
button:
By pushing the “MENU” button the display will show the main menu or you can exit from function and go back to
main menu.
By pushing the “MENU” button when is show the DMX address, you will enter in the main menu.
• address setting
ADR
• channels number setting
CHN only RGBW-DW
• MASTER/SLAVE and AUTOMATIC mode
AUT only RGBW-DW
• FIXED COLOURS mode
COL only RGBW-DW
• LED temperature
TEM
• Default setting
DEF
• Software release
REL
UP
and
DOWN
buttons:
By pushing the “UP” and “DOWN” buttons, values of the function which is shown in the display can be changed.
ENTER
button:
Keep the “ENTER” button pushed, until the display and the SET led flash, in order to memorize the function which
is shown on the display.
.
5.0 Use of the unit
