The following table shows the light output colour effect according to the programme.
It possible to adjust the length of the programmes by using the dip-switches Time1 and Time2.
According to the combination of the two dip-switches, the length of each colour scene can range from 5 to 40
seconds, as shown in the following table.
8.2 SLAVE configuration
To set up the unit as SLAVE adjust all the dip-switches to OFF.
If the unit is properly set up as SLAVE and the signal is present, the red led next to the dip-switch panel will con-
stantly remain on.
The following picture shows an example of configuration of SLAVE units.
8.3 AUTOMATIC configuration
To set up the unit as AUTOMATIC the same instructions for the set up as MASTER must be followed (see paragraph
8.1 MASTER configuration). Adjust the dip-switch Master to ON and choose the programme to be executed.
If the unit is properly set up as Automatic, the red led next to the dip-switch panel will flash.
An internal temperature sensor prevents the unit from overheating. The temperature sensor will limit the current
to leds, protecting their integrity, if the ambient temperature exceeds the one allowed.
9.0 Thermal protection
1 2 3 4 5 6 7 8 9 10 11 12
PR
G
1
PR
G
2
PR
G
3
PR
G
4
PR
G
5
PR
G
6
PR
G
7
PR
G
8
TI
M
E1
TI
M
E2
N
.C
.
M
a
st
e
r
Slave unit (All witch = OFF)
Time1
Time2
Wait time (second)
OFF
OFF
5
ON
OFF
10
OFF
ON
20
ON
ON
40
Program N° Effect
1
Red - Magenta - Yellow
2
Red - Magenta - Yellow - White
3
Green - Cyan - Yellow
4
Green - Cyan - Yellow - White
5
Blue - Cyan - Magenta
6
Blue - Cyan - Magenta - White
7
Base colours
8
Base colours - White
English
29
