Griven AL5020, Руководство пользователя

Страница: 2 / 12

Capital - Rev. 1.0
page 2 of 12
CAUTION: Prolonged staring at LED source should be avoided by placing the fixture in a proper position.
WARNING ! Fixing and connecting operations must mandatorily be carried out by qualified personnel only !
WARNING ! Make sure that power supply is off before connecting or disconnecting fixtures !
Important notices
- This product must be installed in accordance with the local applicable electrical and construction co-
des by a person familiar with the construction and operation of the product and the hazards involved.
Failure to comply with the following installation instructions may result in death or serious injury.
- Do not stare at the operating light source.
- The fixture might be damaged by excess voltage. The installation of an overvoltage protection device on the
electrical system can reduce the risk of damage.
- The use of an adequate magnetothermic switch along the power supply line is recommended.
- Connect the fixtures one to each other only when disconnected from mains power.
- Never leave cables and connectors disconnected or unprotected for long periods.
- Disconnect mains power before installing or servicing to avoid electrical shock.
- Disconnect mains power before any connection operation.
- Check voltage and frequency before powering the fixture. Do not exceed the fixture specified voltage.
- Do not handle the unit with wet hands or in wet environments.
- Apply to qualified staff for any maintenance service not described in this instructions manual.
- Do not exceed the maximum quantity of fixtures per line in order to avoid power surges.
- Before powering the unit, ensure to use cables and connectors with proper section and length, according to its
power consumption.
- Fix the projector by using screws, hooks or other adequate supports that can bear its weight.