www.gripone.com
the installation of the wire to the TPS for experienced users only, on motorcycles that are not
equipped with dedicated analog output (such as that used by the data acquisition system).
The TPS wire has two poles:
Red = signal of TPS
Blue = ground
The TPS signal is used by the control unit via a number of parameters that are described in the
software manual GRIPONE WINSOFT.
6.0
Main switch
I
nside the kit there are a mounting bracket and a toggle switch through which you can disable or
enable the control system. The toggle switch must be fixed on the bracket in a specific way (see
figure below). There is a
small
hole on the
bracket for the tab of washer. The tab must fixed into
the
small
hole from the back side.
7.0
Installation of sensors
To calculate the speed of the motorcycle, GRIPONE P3 uses two proximity sensors. The sensors
must be arranged so that they detect the passage of the screws of the brake disc front and rear.
In the kit is provided a system of universal brackets for mounting sensors. The front bracket must
be placed using the screws of the fork leg that tighten the axle nut. The rear brackets must be
fixed under the rear axle nut.
