www.gripone.com
1.0 Included into the kit
ECU
X 1
Kit of bracket
for sensors X 1
Speed sensor X 2
USB cable X 1
Software (CD) X 1
2.0 Security
During the installation of this product, it is recommended to position the motorbike in such a way
that is cannot cause any injury or damage by falling down or moving forward or backward; it is
recommended to use the rear stand or, if necessary, the wheel lock. Make sure that the injection
system is always turned off and that the electrical equipment is not being powered during the
installation of this product (and, as well as, during all assembly phases indicated in this manual).
When adding or removing electrical cables or wiring to/from the motorcycle’s equipment, always
be sure to remove the negative battery terminal before the positive battery terminal. During
reassembly phases, connect the negative terminal last in order to avoid short circuiting the
electrical equipment.
3.0 Installation recommandation
DO NOT RUSH! When installing the GRIPone control unit, make sure that the unit is protected
from excessive vibrations and surrounding elements and that it is clamped firmly. When you use
the adhesive parts (for setting up the control unit or cables), make sure that the mounting surfaces
are clean and free of dust or grease by cleaning them with degreasing solution. When positioning
the wiring, make sure that the wires cannot be pinched or crushed which may cause subsequent
malfunctions, clamp them as necessary. For safe and professional assembly, it is recommended
that you solder the connections when possible and use thermo-tightening bands to isolate the
various conductors. Place the hot part of the welder on the ends of the wires before putting them
in contact with each other. Do not hesitate to contact the vendor/supplier for assistance if you
encounter any difficulties with the installation of this device. WARNING! The GRIPone control
