G-SWA
Assembly and Operating Manual
2 Safety
2.1 Symbol
2.2 Intended use
2.3 Environmental and operating conditions
2.4 Safety indication
Dangers may arise from the unit, if:
•
the product is not installed or inserted properly,
•
the system is not used for its intended purpose,
•
the safety and installation notes are not observed.
CAUTION! Never open the connector when the load is suspended!
3 Warranty
3
If the product is used as intended in 1-shift operation the warranty is valid for 24 months from the
ex-works delivery date under observance the mandatory maintenance and lubrication intervals and
the given operating conditions. Generally parts touching the work piece and wear parts are not
part of the warranty. Wear parts are listed in chapter 8.1. The unit is considered to be defective if
its basic function "Lock" is no longer functioning.
This symbol indicates possible hazards to persons or the SWA
Connector.
Use this unit only in dry and splash-proof environments at room temperature as well as within the
application parameters defined in the technical specifications. If this is not the case, warranty
cannot be accepted. Exceptions are units designed especially for the respective conditions.
Everyone who is responsible for assembly, commissioning and maintenance must read and
understand the complete operating instructions. Improper use, which affects the function und
operational safety of the SWA Connector, is prohibited.
In order to prevent damage to the connector as well as injuries to the operator, the
lower assembly or the tool must be secured by hand or other devices before opening
the change system. Otherwise there is a risk that irreparable damages to the tool or
injury to the operator are caused by the unit falling down.
NOTICE!
Conduct assembly, maintenance and repair work only outside the hazardous areas or
when the power supply is switched off.
The SWA Connector has been designed as an interface between handling device and tool (e.g. gripper).
Furthermore, the SWA can also be used in special solutions, automation and also as a general
mechanical standard interface. The unit may only be used in the context of its technical specifications.
The system is intended for the installation in a machine. The requirements of the applicable instructions
must be considered and adhered to.
NOTICE!
The unit may only be operated if the machine in which the unit is installed complies with the
relevant provisions of the machinery directive 2006-42-EC.
