Grindmaster GPOD001, Руководство оператора, Страница: 8 / 16

Page 6
Preparing the Brewer for Use - AutoPrime & Flush
This procedure is only required prior to initial use.
Step 1:
Fill water reservoir with clean, room temperature tap or bottled water to the MAX
indicator line.
Step 2:
Place a container with a capacity of at least 32 ounces (1 L) on the cup grate, under
the spout.
Step 3:
Be sure the door on the brewing chamber is latched, plug the unit into a 120V/15A
power receptacle and press the ON/OFF button "ON".
Step 4:
The BREW button will cycle through several colors before pulsing purple. When the
BREW button pulses purple, press and hold the BREW button down for 5 seconds to
activate the AutoPrime & Flush. The AutoPrime & Flush feature only occurs on the initial
use of unit.
Step 5:
The BREW button will turn a solid aqua color while the hot water tank, inside the
brewer, fills and water is flushed through the unit and out the brew spout. Discard the
water that flushes out of the spout and into the bowl after the water stops dispensing
from the brew spout. The water reservoir will be low and should be refilled to the
MAX line before brewing.
Step 6:
Remove the WARNING decal from the ON/OFF button. The BREW button will be
slowly flashing red indicating that the unit is heating. The BREW button will turn green
when the unit is ready to brew coffee or tea.
NOTE: If the unit is not used for an extended period of time, it is necessary to
manually prime the unit upon restarting. To manually prime the unit, be sure water
reservoir is filled to the MAX line, turn the unit "On" and place a 32 ounce (1 L)
container on the cup grate to catch the water that will dispense. Press and hold the
BREW button until water is dispensed from the brew spout (water will begin to
dispense from the brew spout after 5 seconds and the BREW button will be aqua).
Release the BREW button after water is seen coming out of the brew spout to end the
priming function. Discard the water that has been dispensed during priming. The unit
will begin the normal heating cycle (the BREW button will slowly pulse red).