Page 1
INTRODUCTION
The continental series is an attractive, low profile
enclosure that incorporates a precision temperature
sensor used to monitor room temperatures. Additional
options are available that include set-point adjustment,
manual override, fan speed, handset communication
port, and an LCD.
BEFORE INSTALLATION
Read these instructions carefully before installing and commissioning the device. Failure to follow these
instructions may result in product damage. Do not use in an explosive or hazardous environment, with
combustible for flammable gases, as a safety or emergency stop device or in any other application where
failure of the product could result in personal injury. Take electrostatic discharge precautions during
installation.
Do not exceed the device ratings.
MOUNTING
The temperature sensor mounts directly on a wall or onto an electrical wall box. For the most accurate
results, the unit should be mounted on an inside wall to a wall box five feet from the floor. Do not mount
the sensor near doors, opening windows, supply air diffusers, or other known air disturbances. Avoid areas
where the sensor is exposed to vibrations or rapid temperature changes.
The cover is hooked to the base at the top edge and must be removed from the bottom edge first. Use
a small Phillips screwdriver to loosen the security screw as shown in Figure 1. (Complete removal is not
required). Use a screw driver to carefully pry each bottom corner if necessary. Tip the cover away from the
base and sit it aside as shown in Figure 2.
SENSOR ONLY
Feed at least 6 inches of wire through the wall and out of the junction box and feed connection wires
through the center hole on the backplate. Secure the backplate to the wall or electrical box with suitable
screws (not supplied) as shown in Figure 3. The mounting holes in the backplate allow for up, down, and
side to side movement to compensate for unlevel electrical box installation.
Retrieve the sensor with clip. Turn the clip over and remove the
backing from the clip to expose the adhesive back. Stick the
clip on a smooth surface of the backplate. See Figure 4.
Make wire connections as per the Wiring Illustrations on Page 2.
Re-install the decorative cover by placing the top of the cover
into the cover holder on the top of the backplate and snapping
the bottom into place as shown in Figure 7. Tighten security
screw with a screwdriver.
Figure 1
Figure 3
Figure 2
Figure 4
IN-GE-TSRCXXX-01 04/20
Copyright © Greystone Energy Systems, Inc. All Rights Reserved Phone: +1 506 853 3057 Web: www.greystoneenergy.com
Room Temperature Sensor
TSRC Series - Installation Instructions
