Press
È
to
Start
(time) and
Æ
to position the cursor under the time column
HH/MM/SS
(24 hour
clock in Hours/minutes/seconds, eg:
23:02:16
) and then
È
or
Ç
to set the logging start Time. Press
Æ
to return to Start .
Press
È
to Interval and
Æ
to the
Sec/Min
column. Press
È
or
Ç
to set the logging time interval.
Choose:
Press
Æ
to return to to
Interval
and
È
to
Reset Log?
To erase all existing data in the log press
Æ
to
Yes
and
È
. To keep existing data in the Log press
È
from
Reset Log?
If you have made changes
to the Start Date, Time or Interval, the data logger will automatically start a new “session”. The SLT32
will display “
xxxxx Hrs/Days Left
”.
From the
xxxxx Hrs Left
display press
È
to
Store? Yes
. Press
Æ
to
Yes
and then
È
to save
your Data Logging setup, or press
È
from
Store?
to cancel changes made above and exit without
storing changes.
From the Data Logging
Store? Yes
prompt the menu will return to
RUN STOP SETUP
. Press
Æ
to
position the cursor under
RUN
and press
È
to activate the Data Logger to start at your selected start Date
and Time. The SLT32 will display
SESSION NO. x
. Press
È
to return to
DATA LOGGING
.
‘Event’ based Trend Logging
Event
based logging stores data points only when a High or Low flow set point has been reached.
With cursor under
Event
press
È
to
HiAlm LoAlm
.
HiAlm
will log points
above
a selectable flow
rate, while
LoAlm
will log points
below
a selectable flow rate. Position the cursor under
HiAlm
or
LoAlm
and press
È
to the
At:
prompt. Press
Æ
to the numerals column and press
È
or
Ç
to set flow
alarm logging set point. Press
Æ
to return to
At:
SLT32 Level & Flow Monitor
Manual Series B.11
Page 41
30 Sec
10 Sec
5 Sec
2 Sec
1 Sec
30 Min
10 Min
5 Min
2 Min
1 Min
