GreenWorks GPW1804, Руководство пользователя

Страница: 16 / 56

OPERATION
15
Fig. 7
C A U T I O N
Use only approved pressure washer cleaners. Do not use bleach, chlorine,or any cleaners
containing acids.
NOTE:
Use a funnel, if needed, to prevent accidental spilling of the detergent outside the tank.
before proceeding.
STARTING AND STOPPING THE PRESSURE WASHER
See Figure 8.
C A U T I O N
Do not run the pump without the water supply connected and turned on.
• Connect the garden hose.
• Turn the water supply on, then squeeze the trigger and run water hose with motor in OFF
position until a steady stream of water appears. This helps drain air from tank and lines.
NOTE:
If the pressure washer pulsates and the water stream is intermittent turn the pressure
washer off and continue to bleed air out of the system. Ensure to check that the garden hose is
fully turned on and not kinked.
• After ensuring the On/Off switch is in the OFF ( O ) position, connect the pressure washer
to the power supply.
• Press the reset button on the pressure washer’s plug to make sure the unit is ready for
operation.
• Press the switch to ON ( I ) position to start the motor.
• To stop the motor, release the trigger and press the switch to OFF( O ) position.
NOTE:
The pressure washer may be on and the system may have pressure even when the
pump and/or motor cannot be heard running. Always use caution around the pressure washer.