1
2
3
For charger: CAM812/ CAM813
1
2
3
CHARGING PROCEDURE (LED INDICATOR)
BATTERY IS CHARGING
GREEN
BLINKING
FULLY CHARGED
GREEN
BATTERY IS TOO WARM (RE-
MOVE FOR APPROX. 30 MINUTES
TO ALLOW TO COOL)
RED
DEFECTIVE BATTERY (REMOVE
AND REPLACE WITH A NEW BAT-
TERY)
RED
BLINKING
1. Put the battery pack into the charger.
•
If the status LED blinks RED, remove the battery
pack from the charger for 1 minute.
2. Put the battery pack into the charger again.
•
If the status LEDs show correct, the battery pack is
good.
•
If the status LED stays blinking RED, remove the
battery pack and disconnect the charger.
3. Wait for 1 minute and put the battery pack into the
charger again.
•
If the status LEDs show correct, the battery pack is
good.
•
If the status LED stays blinking RED, the battery
pack is defective and it is necessary to replace the
battery pack.
6.2
EXAMINE THE CHARGER
If the battery pack does not charge correctly:
1. Examine the current of the power outlet with different
machines. Make sure that the outlet works.
2. Examine that the charger contacts are not short-circuited.
3. If the charger is not under usual room temperature, move
the charger and battery pack to a location where the
temperature is between 6 ˚C and 40˚C .
WARNING
If you put the battery pack into the charger in warm or hot
environment, the charger LED light is red. Pull out the
battery pack and let the battery cool for approximately 30
minutes.
6.3
MOUNT THE CHARGER
1. Get the location of the wall to attach the charger.
2. Use 2 wood screws to attach the charger on the wood
studs.
3. For charger CAM803/ CAM801: Drill two paralleled
holes 5” (127 mm) on center. For charger CAM812/
CAM813: Drill two paralleled holes 4.4” (112 mm) on
center.
4. Use wall anchors and screws to attach the charger to the
drywall.
CAM803/ CAM801
CAM812/ CAM813
NOTE
If you do not use the battery pack and charger for a long
time, please remove the battery from the charger and pull
out the AC power plug.
6
English
EN
Содержание CAM811
Страница 2: ......
