English (original instructions)
EN
DE ES IT FR PT NL RU FI SV NO DA PL CS SK SL HR HU RO BG EL AR TR HE LT LV ET
37. Log supported both ends
38. Bucking a log
39. Stand on uphill side when cutting because log may
roll
ASSEMBLY
This chain saw does not require assembly, but user should
know how to assemble the guide bar and saw chain.
Check the chain tensioning and add oil as described later
in this manual before each operation.
ASSEMBLiNG THE GUiDE BAR AND SAw CHAiN
See figure 2 - 7
Make sure remove the battery pack from the unit. Wear
protective gloves.
Unscrew the sprocket cover tighten knob (item 10)
and remove the sprocket cover.
The saw chain should face in the direction of chain
rotation. If they face backwards, turn the loop over.
Place the chain drive links into the bar groove.
Position the chain so there is a loop at the back of
the bar.
Hold the chain in position on the bar and place
the loop around the sprocket and make sure it is
correctly mounted. Make sure the bar hole fits well
with bolt (item 16) for saw chain tension.
Replace the sprocket cover, turn the chain tension
adjust knob (item 11) clockwise until the saw chain
is properly tensioned. The guide bar must then be
pushed upwards, check chain tension again, do not
tension the chain too tight.
After the chain is well-tensioned, tighten the knob
(item 10) again.
NOTE:
The saw chain is properly tensioned if, in the
middle of the guide bar, it can be lifted 3mm to 4mm from
the edge of the guide bar. Start the saw again with a new
saw chain, allowing it to run-in for 2~3 minutes.
wARNiNG
After the run-in time, check the chain tension and
retighten the chain if necessary.
OPERATiON
For complete charging instructions, refer to the
Operator’s Manuals for your Greenwork battery pack
and charger models.
NOTE:
To avoid serious personal injury, always remove
the battery pack and keep hands clear of the lock-out
button when carrying or transporting the tool.
BEFORE EACH USE CHECKiNG THE CHAiN
TENSiON
wARNiNG
Remove the battery pack from the chain saw before
checking the chain tension or making adjustments to
the chain. Wear protective gloves while touching the
chain, bar or areas around the chain.
Pull the chain in the middle of the lower side of the bar
away from the bar. The gap between the cutter in the
chain and the bar should be between 3mm - 4mm.
If you need to adjust the chain tension, please refer to
the section “ADJUSTING THE CHAIN TENSION” later
in this manual.
TO iNSTALL BATTERY PACK
See Figure 2.
Align the battery pack with the battery compartment
on the chain saw.
Grasp the chain saw firmly.
Push the battery pack into the battery compartment
until the latch locks into place.
You should hear a "click" once the battery is installed.
TO REMOVE BATTERY PACK
See Figure 2.
Press the battery release button on the chain saw.
This will cause the battery to raise out of the tool
slightly.
Grasp the chain saw firmly, and pull the battery pack
out of handle.
CHECKiNG THE CHAiN LUBRiCANT
See Figure 2.
Check the amount of oil in the chain saw by looking
at the quick view oil indicator ( item 5).
If the oil level
is low, follow the steps shown in section “ADDING
CHAIN & BAR LUBRICANT” of this manual.
