11.2
ASSEMBLE THE CASTERS
7
1. Align the caster with the tank and slide it into the place.
2. Insert the screw and tighten it with a Phillips head
screwdriver (not included).
3. Repeat the above steps four times.
11.3
ASSEMBLE THE ACCESSORY
HOLDER
1. Align the accessory holder with the tank and slide it into
the place.
2. Insert the screws.
3. Use a phillips screwdriver (not included) to tighten.
11.4
INSERT THE HOSE
1. Align either of the grooves in the tube with the tabs on
the hose.
2. Insert the locking end of the hose into the port on the
collection tank and turn clockwise to lock into place.
3. Insert your desired accessory onto the end of the hose
securely.
11.5
INSTALL THE BATTERY PACKS
12
12
NOTE
In DC mode, install two batteries at the same time to start
the machine.
1. Align the lift ribs on the battery pack with the grooves in
the battery compartment.
2. Push the battery pack into the battery compartment until
the battery pack locks into place.
3. When you hear a click, the battery pack is installed.
8
English
EN
