7
KNOW YOUR MACHINE
7.1
CONTROL PANEL
7.1.1
CONTROL PANEL
#
Name
Function
1
Power
switch with
start key
The power switch is used to turn the
mower on and off. The start key must be
inserted before the switch can be operat-
ed.
2
Digital dis-
play
This display shows important electrical
system information. Refer to the Electri-
cal section for complete information.
3
ON/OFF for
blade (PTO)
Pull the blade engage knob up to activate
the mower’s cutting blades. Push the
knob down to stop the cutting blades.
4
High/Low
for blade
speed
High blade mode is a higher blade speed
for cutting thicker grass, while low blade
mode provides lower blade speed for
lower battery consumption on thinner,
drier grass areas.
NOTE
Mowing time will be increased when
mowing in low blade mode.
#
Name
Function
5
High/Low
for driving
speed
Allows operators to select a comfortable
driving speed. Pressing it to “High
Speed"” position means that the maxi-
mum drive speed will be 8 mph. Pressing
it to “Low Speed” position means that
the maximum drive speed will be 4 mph.
Press it to “Low Speed” position for in-
experienced operators or when trimming
around objects, buildings and other ob-
stacles.
NOTE
Get comfortable with mower before us-
ing “High Speed” setting. The maxi-
mum speed may be adjusted at any
time, whether the mower is in motion
or not.
7.2
STEERING CONTROL LEVERS
The two levers control the mower’s speed, direction,
stopping, neutral lock, and parking brake. Levers are used to
steer, accelerate, decelerate, stop, and change direction. When
the control levers are in the park brake position, the mower
will not move.
7.3
ANTI-SCALP WHEELS
Anti-scalp wheel kits are standard on Greenworks
Commercial units. These anti-scalp wheels (23) are designed
to minimize scalping when mowing on rough, uneven terrain.
After setting the cutting height, adjust the anti-scalp wheels
so they extend below the deck but do not contact the ground.
They should always be at least 1/4" to 3/4" below the deck.
With the unit sitting on a flat level surface, the wheel position
can be adjusted up or down as needed from 3/4" to 1-3/4"
below the blade surface. Move the wheels up or down - using
the different axle mount holes in the wheel mount bracket (if
applicable on model).
7.4
NEUTRAL BYPASS KNOB
1. Pull the neutral bypass knobs outwards and then
downwards to unlock the wheel.
2. Move the neutral bypass knobs back into position to lock
the wheels.
7
English
EN
P0803155-00 v1.3