Problem
Cause
Solution
The blade fails
to run when you
pull up the PTO
switch.
1. There is no battery inserted that controls the left
or right blade function.
2. The battery compartment that controls the blade
is out of power.
3. The seat switch is not connected.
4. The PTO switch is not in the OFF position when
the machine is powered on.
5. The blade motor is blocked or other functional
protection.
6. The discharge system of the left or right blade
battery compartment is in the sleep state.
1. Make sure at least one Greenwoks designed bat-
tery pack is inserted in the battery compartment
that controls the left or right blade.Make sure the
battery pack has power.
2. Make sure at least one green light on the battery
pack is on.
3. Make sure the operator is sitting on the seat, if
not, the beeper will alarm.
4. Push down on the PTO switch, restart the ma-
chine.
5. Cut the grass in low blade speed when you power
on the machine, set the blade speed to high posi-
tion once the machine cuts normally. Check if the
connection between the blade and motor is with-
out grass or foreign objects to ensure the blade
rotates smoothly.
6. Restart the machine.
The blade stops
running during
the mowing
process.
1. The blade motor is overheated.
2. The deck is full of grass and garbage.
3. The blade motor is overloaded.
4. The battery pack termperature is too high.
5. The battery is undervoltage.
6. The blade is hit by a foreign object, causing the
blade to stop suddenly for protection.
1. Do not use the machine too much, power off the
machine for 5min. Raise the deck height or re-
duce the driving speed to protect the blade.
2. Clean the deck to ensure that the blade rotation is
normal.
3. Push down on the PTO switch; restart the ma-
chine. Raise the deck height or reduce the drive
speed to protect the blade.
4. The battery pack stops working once it is over-
temperature. wait until the battery pack cools
down. Make sure at least one battery pack is in-
serted for each function.
5. The battery pack that controls the blade system is
under voltage. Charge the battery immediately.
6. Push down on the PTO switch and restart the ma-
chine.
The beeper
alarms.
1. The person leaves the seat when the vehicle is
powered on.
2. The display shows abnormal communication.
1. Return the steer control levers to Neutral position
when you finish working; if you will leave the
seat for a long time, power off the machine.
2. Check if the connection of the display communi-
cation is OK. If the connection is OK, but the dis-
play is still black, contact a service center for
help.
The machine
cuts the grass
unevenly.
1. The blade is dull.
2. The blade is bent.
3. 3. The deck is uneven.
1. Grind the blade according to the manual.
2. Replace the bent blade, replace the blade accord-
ing to the instructions in the manual, and wear
protective equipment.
3. Adjust the cutting deck according to the instruc-
tions in the manual to ensure the left and right
deck height are even.
The actual cut
height does not
match the cut
height you set.
1. The bolt of the deck is loose.
2. The deck is severely worn or damaged.
1. Adjust the cutting deck bolt,make sure the deck
is not loose. Please balance the deck level after
each adjustment.
2. Replace with a new cutting deck.
24
English
EN
P0803155-00 v1.3
