GreenWorks Pro 2605902, Руководство оператора

Страница: 13 / 41

WARNING
Make sure to turn off the bail lever and remove the battery
pack(s) before performing any maintenance task on your
snow thrower.
1. Remove the 4 sets of nuts and bolts on the middle steel
plate.
2. Remove the 4 sets of nuts and bolts on each side.
3. Remove the impellers (10).
4. Install the new impellers (10).
5. Tigthen the 8 sets of nuts and bolts that you removed.
9.5 REPLACE THE SKID PLATES
NOTE
The range of adjustable height for skid plates is 1.5mm,
when putting the bolts through the U-hole on the skid
plates.
1. Loosen the 2 sets of bolts (17), spacers (31) and nuts (19)
that attach the skid plates (30) to the snow thrower
housing.
2. Remove the skid plates (30).
3. Install the new skid plates (30).
4. Do the same operation on the other side.
9.6 STORE THE MACHINE
• Clean the machine before storage.
• Make sure the motor is not hot when you store the
machine.
• Make sure that the machine does not have loose or
damaged parts. If it is necessary, do these steps/
instructions:
• Replace the damaged parts.
• Tighten the bolts.
• Speak to a person at an approved service center.
• Store the machine in a dry area.
• Make sure that children cannot come near the machine.
10 TROUBLESHOOTING
Problem Possible cause Solution
The handle is not
in position. The bolts are not
engaged correctly. Adjust the height
of the handle and
make sure that the
knobs and bolts
are aligned cor-
rectly.
The machine does
not start. The battery is not
charged. Charge the battery
by following the
procedures in the
battery and charg-
er manual.
The switch is de-
fective. Have the switch
replaced by an au-
thorized service
center.
Battery is too cold. Remove battery
from snow throw-
er. Place battery on
charger and allow
to charge for 10
minutes or until
the changing light
turns green. Re-
move from charger
and install in snow
thrower for use.
Battery may re-
quire service or re-
placement. Call toll free help-
line, at
1-855-345-3934 or
replace battery.
The engine is on,
but the impeller
does not turn. The belt is dam-
aged. Replace the belt.
A thin layer of
snow stays behind. The scraper is
damaged. Replace the scra-
per.
* If you cannot find the solution to these problems, call
1-855-345-3934 .
11 TECHNICAL DATA
Voltage 80 V
No load speed 1800 RPM
Clearing width 22 in (55.9 cm)
Clearing depth 13 in (33.0 cm)
Impeller size 18 in (45.7 cm)
Weight (without battery
pack) 25.8 kg (56.9 lbs)
12
English
EN
17 30 31 19