GreenTec RC 162, Руководство пользователя

Страница: 29 / 52

Hedge Cutter RC 162 29
It can be an advantage to use the ”Ear lifter” (Optional
equipment) at the bottom of the hedge cutter to lift smaller
twigs closer to the knives. Caution must be taken when
working close to the ground.
Smaller adjustments of the cutting angle can be done when
driving but it is recommended to stop working when making
larger adjustments.
To prevent the knives from blocking the lower ones are
mounted to swing freely at an 360
0
angle. The upper ones at
110
0
. A non-return valve is mounted on the hydraulic system
to slow down the knives faster. If the knives block despite
this, stop the cutter, stop the vehicle, remove ignition key,
engage the handbrake, use safety glasses and work gloves
and remove the unwanted stuck material.
When the sap disappears from the branches the end result will
become more ”frayed”. When operating off growth season the
knives will wear out faster
.
DRIVING DIRECTIONS FOR HEDGE CUTTER:
Always start and stop the tool at the lowest pto rpm./ olieflow.
Choose a suitable forward drive depending on the hedge, surface, traffic and visibility.
We recommend that you start driving slowly, allowing the knives to reach the
recommended speed. Adjust the cutting angle to be approximately 90° against the
branches. If reaching a larger branch, adjust the cutting height to meet the branch
”straight on”, lower the speed to a minimum and “plane” off the branch.
If smaller twigs or other unwanted material get stuck between the knives, stop the
machine and remove it.
Where possible, the knives have to cut vertical in the direction of travel. This prevents
the knives from bending during work.