SG4-854 Shotgun Shoe Group for 854DX Electric Bender
Greenlee Tools, Inc.
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070
9
Operation
(cont’d)
LENGTH INDICATOR
Use the length stop accessory for fast setup of identical
bends on the shotgun shoe.
1. Load the conduit into the shoe so that the bending
mark is aligned with the front of the hook.
2. Install the long clamp assembly into the proper
mounting hole near the end of the shoe groove.
3. Install the short clamp assembly into the proper
mounting hole near the start of the shoe groove, as
shown.
Install
long clamp
near end
of groove.
Install short clamp
near start of groove.
4. Slide a piece of scrap conduit, square tube, or
bar through the two clamps and tighten the clamp
screws. Make sure the back of the conduit is shorter
than the shoe radius.
5. Slide the stopper assembly onto the tube or bar
until the stopper contacts the conduit and tighten
the clamp screw, as shown.
Install tube or bar
through clamps
and tighten
screws.
Install stopper assembly
onto tube and slide
against conduit.
Tighten clamp screw.
Back edge is shorter
than shoe radius.
6. Install the additional length of conduit into the shoe
until the ends contact the stopper assembly.
7. Press
BEND
to bend the conduit lengths to the
desired angle.
8. Press
UNLOAD
to rotate the shoe backwards
approximately 10° to remove the load on the hook.
9. Remove the hook and unload the conduit lengths.
