SG4-854 Shotgun Shoe Group for 854DX Electric Bender
Greenlee Tools, Inc.
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070
7
Setup
(cont’d)
INSTALLING A SHOTGUN BENDING SHOE
1. Rotate the support to sit on the eccentric shaft, as
shown.
2. Slide the shotgun bending shoe onto the shaft of
the main sprocket, as shown. Align the four drive
studs on the back of the shoe with the four holes in
the main sprocket. Make sure to align the drive stud
with the cap with the bigger hole on the bender.
PENDANT SETUP
1. Attach the pendant cord to the receptacle located
on the back of the bender.
2. Turn on the power to the bender.
3. Press and hold the
CLEAR
button on the
pendant; then in addition press and hold
the
ANGLE SELECT
p
button.
4. Continue to hold both buttons until the
text “SHOTGUN” scrolls across the
pendant and the last decimal point on the
pendant is on continuously. The buttons
must be held for approximately 2 seconds.
The second decimal point will remain on
while the bender is in SHOTGUN mode.
5. Load the conduit into the proper shoe
groove.
6. Press
BEND
momentarily until the shoe rotates
enough so that the conduit is snug in the hook.
7. Press and hold the
CLEAR
button for 3 seconds to
make the pendant read “00”.
8. Using the supplied bending table for the SG4-854,
bend the conduit until the pendant reads the appro-
priate degree.
