Greenlee / A Textron Company
9
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070
EK410 Battery-powered Crimping Tool
Maintenance
Each Operating Day
Before use:
1. Inspect dies for wear or damage such as cracks,
gouges, or chips.
2. Inspect the tool for damage or leaks. If damage is
detected, return the tool to an authorized Greenlee
service center for inspection.
Skin injection hazard:
Do not use hands to check for
oil leaks. High pressure oil easily
punctures skin causing serious
injury, gangrene, or death. If injured,
seek medical help immediately to
remove oil.
Do not use solvents or flammable
cleaners to clean the tool body.
Solvents could ignite, causing
serious injury or property damage.
After use:
1. Wipe all tool surfaces clean with a damp cloth and
mild detergent.
Troubleshooting
Before You Begin
1. Make sure that the battery is charged. Recheck
the battery after several minutes to make sure the
battery is holding its charge.
Tool is inoperative.
Dirt, contaminants, etc., in ram area
Clean tool.
of tool.
Crimping tool battery contacts
Reform contacts.
damaged.
Tool components worn or damaged.
Return tool to an authorized
Greenlee service center.
Dies stop during operation.
Oil level is low.
Return tool to an authorized
Greenlee service center.
Air in hydraulic system.
Pull trigger and hold retract button
simultaneously. Hold for approximately
10 seconds.
LED glows for 20 seconds.
Battery charge low.
Charge or replace battery.
Tool loses oil.
Damaged internal seal.
Return tool to an authorized
Greenlee service center.
2. Use a
nonflammable
contact cleaner or pencil
eraser to clean the electrical contacts on the battery
and crimping tool.
3. Reinstall the battery and check the tool again.
Probable Cause
Problem
Probable Remedy
2. Fully retract the ram. Place the tool in the carrying
case. Store in a cool, dry place.
3. Charge the battery.
Monthly
1. Thoroughly clean all surfaces.
2. Oil the pin joints.
Annually or After 10,000 Crimps
Return the tool to an authorized Greenlee service center
for inspection.
