Greenlee CM-410, Инструкция по эксплуатации

Страница: 8 / 48

8
Operation
1. Set the selector switch according to the Settings Table. Momentarily
press the select/toggle button to select mode.
2. Refer to “Typical Measurements” for specific measurement
instructions.
3. Test the unit on a known functioning circuit or component.
• If the unit does not function as expected on a known functioning
circuit, replace the battery.
• If the unit still does not function as expected, send the unit to
Greenlee for repair. Refer to the instructions under the Warranty.
4. Take the reading from the circuit or component to be tested.
Settings Table
Electric shock hazard:
Contact with live circuits could result in severe
injury or death.
To measure
this value …
Connect
red lead
to …
Connect
black lead
to …
Momentarily press
the Select/Toggle
Button until this
icon appears
on the display …
Set the
Selector Switch
to this
symbol …
AC Amps* N/A N/A N/A
AC Voltage V-Ω COM
DC Voltage V-Ω COM
Continuity** V-Ω COM
Resistance V-Ω COM
M Ω
* AC Amp measurements are made using the jaw clamp. Refer to “Typical
Measurements” for specific measurement instructions.
** Tone indicates a circuit resistance of less than 20
Ω
.