Greenlee 93-606, Инструкция по эксплуатации

Страница: 9 / 48

93-606
9
Operation
1. See the Settings Table. Set the selector to the proper setting and connect the test leads to
the meter. Start with the highest measurement range.
Settings Table
* Tone and symbol on display indicate continuity. Threshold is approximately 80
Ω
.
** Insert the legs of the transistor (emitter, base and collector) so they correspond to the
terminals (E, B and C).
2. See Typical Measurements for specific measurement instructions.
3. Test the unit on a known functioning circuit or component.
• If the unit does not function as expected on a known functioning circuit, replace the
battery and/or fuses.
• If the unit still does not function as expected, send the unit to Greenlee for repair.
4. Take the reading from the circuit or component to be tested. If the resolution is not
satisfactory, remove the meter from the circuit and change to the next lower range.
To measure set the selector
this icon will connect and connect
this value … to this symbol …
appear on the red the black
the display … lead to … lead to …
Continuity*
Ω
V
Ω
COM
Current (AC)
A (no icon) A COM
10 A Range
Current (AC)
A
µ
A, mA, or no icon mA COM
Other Ranges
Current (DC)
A (no icon) A COM
10 A Range
Current (DC)
A
µ
A, mA, or no icon mA COM
Other Ranges
Diode (no icon) V
Ω
COM
Frequency Hz KHz or MHz V
Ω
COM
Resistance
Ω Ω
, K
Ω
, or M
Ω
V
Ω
COM
Voltage (AC) V V or mV V
Ω
COM
Voltage (DC) V V or mV V
Ω
COM
Transistor Gain** PNP or NPN (no icon) N/A N/A