Greenlee 920XC-13A, Инструкция по эксплуатации

Страница: 34 / 128

34
Greenlee / A Textron Company
Trace Measurement
One complete trace can be obtained for each measurement. The 920XC can also load a saved
trace.
Setup
Connect the optical fiber directly to the 920XC optic output. No tools are required.
Clean the connectors. Refer to Section 5 of this manual for details.
Clean the tie-ins, making sure they are compatible (APC or UPC).
Connect optical fiber to the 920XC.
For details relating to parameter configuration, refer to “Parameter Configuration” in Section 3. If
the.parameters.are.unclear,.use.the.default.parameters.of.the.instrument.
Note: Range is set to “Auto” when auto measurement is on.
Auto Trace Measurement
Auto measurement can be used if the length of optical fiber is unknown. The 920XC will select an
adequate range for measurement.
For auto measurement follow these steps:
1. Set the range to “Auto.” Refer to “Parameter Configuration” in Section 3.
2.. Press.
Run/Stop
to start the measurement (Figure 4-3).
Figure 4-3. Measuring
3. Interface:
Total: 00:30: .Measure.time,.which..is.set.by.user,.is.30.seconds.
Passed: 00:16:
.Total.measurement.time.has.passed.16.seconds.
: Blinking of this icon means laser is active.
•
•
•
•
•
•
Instrument damage hazard:
Make sure that the optical fiber or cable is not in use and there is no laser beam in the fiber
before.testing.with.this.unit.
Failure to observe this precaution may result in injury and may damage the unit.
Section 4