– 16 –
C R O S S C O U N T R Y F I V E - W A L L S E R I E S S T R A I G H T L E A N T O • G R E E N H O U S E I N S T R U C T I O N S
A
B
C
1.
BACK GABLE END
(See Page 19)
Take the assembled back gable end
and stand it up on your foundation.
(Slide a bolt into the top of the
corner post or use the push-out in the
back of the Poly Bar, move it down
approximately 3” and temporarily
tighten the bolt.
)
2.
SIDE WALL
(See Page 19)
Stand up side wall. Slide the gutter
(sidewall)
in between the end rafter
and the corner post.
(There should
be a 1/8” space - See Picture
A
).
By
sliding the gutter in as far as it goes,
the punched out slots line up with
the bolt track in the backof the Poly
Bar
(See Picture
B
).
Undo the bolt
in the corner and slide it up into
the slot and tighten up. Fastenthe
bottom base
(See Picture
C
).
Make
sure the side base fits in between the
corner and end base.
3.
FRONT GABLE END
(See Page 19)
Follow the same procedure as the
back gable end.
Aluminum Frame Assembly
& Installation
Gutter
End
Base
Side
Base